Building wooden hanging garage shelves can be a great way to maximize storage space while keeping your garage organized. Here are some steps you can follow:
- Cut the Legs to Length:
- Start by placing four studs on edge, side by side, and ensuring they’re evenly aligned on one end.
- Mark one of the boards at 72 inches using a tape measure.
- Cut each board to length at the marked point using a circular saw or miter saw1.
- Cut the Shelf Frames to Width:
- Place another four studs side by side and align their ends.
- Mark one of the studs at 48 inches using a tape measure.
- Cut all four studs to this length using a miter or circular saw, resulting in eight 48-inch-long boards1.
- Cut the Shelf Frames to Depth:
- Take two studs and align their ends.
- Mark one stud every 13 inches (13, 26, 39, 52, 65, 78, and 91 inches) using a tape measure.
- Cut the boards at all six marks, resulting in twelve 13-inch-long boards1.
- Pre-drill:
- Pre-drill the 48-inch boards by drilling two holes in the face of each board, ¾ of an inch from each edge.
- Also, drill two holes in each of these boards at 24 inches (center)1.
- Assemble the Frames:
- Separate the boards into four piles: two 48-inch boards and three 13-inch boards for each frame.
- Apply a bit of glue or construction adhesive to the edge of each short board.
- Place the shorter boards between the 48-inch boards to form the frame.
- Use 2 ½-inch wood screws to attach the shorter boards to the longer boards, ensuring the frame remains as square as possible during assembly1.
- Hang the Shelves:
- Once the frames are assembled, hang them on the wall using appropriate hardware.
- Make sure to secure them to wall studs for stability.
- You can use angle brackets or other hanging hardware to support the shelves2.
Remember to adjust the measurements and customize the design according to your garage space and storage needs. Good luck with your project! 😊
